Some people install backplates simply for the aesthetic effect.Īdjustable pulls are pulls that allow you to change the length of the pull. They also help cover exposed holes or damage caused by older cabinet hardware. They serve a variety of purposes, the most important one to protect the wood surface from dents and stratches. Bar pulls or knobs would work better for those types of drawers.īackplates are used along with a knob or a pull. Standard-sized drawers with a deep inset don't work well with cup pulls simply because you have to reach your hand in far to reach the pull. Thin drawers can look clunky with a cup pull and it can be difficult to reach your fingers underneath the pull if a thin drawer has an inset. However, cup pulls don't work on all types of drawers. Replacing the cabinet hardware in a kitchen is the quickest and most inexpensive way to update the look of your kitchen.Ĭup pulls can make it easy to pull open drawers and add a chic and modern vibe to any kitchen. Depending on the height of the door, ths may or may not put the hardware in the middle of the door. This will make it comfortable to use, and allow children to still reach it. When mounting an appliance pulls on a pantry or other tall cabinet door, we recommend mounting the hardware at the elbow level of an adult. This will keep them from being too far apart. When using two smaller pieces of hardware, the pieces should be mounted on the thirds. We recommend using an appliance pull or two smaller pieces of hardware for these applications. On wide drawers, sometimes smaller pieces of hardware can get lost. On drawers, drill two new holes and realign in the center.On base cabinets, reuse the top hole and drill a new bottom hole.On wall cabinets, reuse the bottom hole and drill a new top hole.When it comes to re-using previously drilled holes, the following information should assist you: This will allow you to mark where you should drill before you start working. It may be helpful to purchase a pull installation template before you start working. When mounting pulls on drawers, align the holes in the center of the drawer front. Usually, hardware is placed on the door stile, but with some styles of doors, hardware placed in the center of the door can be an attractive option.īest Knob and Pull Cabinet Placement Options When mounting pulls (handles) on cabinet doors, place the bottom hole in the upper third of the door for lower cabinets, and the upper hole in the lower third of the door for upper cabinets. When mounting knobs on cabinet doors, place the knob in the corner of the door. However, some kitchens may use all knobs or all pulls, or any combination that best suits your style. Traditionally, knobs are used on cabinet doors, and pulls (handles) are used on drawers.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |